Bucket Elevator Belts

Bucket Elevators Belts

When conveyor belts are used as bucket elevators then there are a series of different possibilities, depending on the particular system in question.

The belt width ranges from 180 to 2200 mm. The standard manufactured width is 1400 mm.

The different possible types of centres are:

a) EP (polyester –polyimide) fabric textiles, consisting

of 3 to 7 plies, with the most common resistances being:
EP 500/3 -EP 630/4 – EP 800/5

b) Single layer EPP textile fabrics, with the most common resistances being: EPP 500 -EPP 630 – EPP 800

c) SW metallic type centres (see Kauflex belt section), consisting of two normally rigid wefts and with a warp resistance of:
SW 630 RE - SW 800 RE - SW 1000 RE - SW 1250 RE

d) 28 ounce to 32 ounce, rubber impregnated cotton textile with no outer coating. The warp resistance is the same as the above cases. From 3 to 6 plies.

he most commonly used covers are 2 + 2 mm thick for general cases and 3 + 3 mm for heat-resistant belts (150 'C  and 200 'C respectively).

As for the characteristics of the rubber cover, see the “Rubber characteristics” section, as the most appropriate class of rubber for each case will be used.

 

For more information and buy equipments , kindly contact sales department.